| Version |
Changes |
2.2
20Nov01 |
Aides
device recognition within Windows XP and
Mac OS X |
1.9
0400 |
Improvement to scan
speed in Fast Mode, when scanning below 1200dpi optical res; support
new A/D on rev G mainboard; small improvement to scan quality
in transmissive/UTA mode (no further details given). [source:
TUP2K011] |
1.7
0799 |
Increases scan speed
for Quality mode 600-1200dpi, improves Speed mod calibration method,
increases initial (power-on) warm-up time to allow scanner lamp/CCD
to stabilise. [source 060899] |
1.6
070598 |
Reduces calibration
time by 5 seconds, reduces warm-up time by 20 seconds; stops scanner
from always doing complete "warm-up" procedure when
swapping from UTA to FB or FB to UTA mode; improves "image
shift" problem of image area moving in final scan; solves
occasional linking problem with Adaptec 1542CP. [source TU98005] |
1.5
010298 |
Solve problem of "stripes"
in scans, improve colour balance across width of scan to prevent
green/red cast near left or right hand edge; EEPROM; [source 130398MN,
TU980206-001S] |
1.4
171297 |
Modify UTA motor stepping
for return to home position, solve "time out" error
in batch scan mode, solve problem of lower section of image having
a green or red colour cast, introduce pause in tranny scanning
to prevent UTA motor "snagging" (chassis stops during
scan); change to EEPROM; [source TU971208-020S] |
1.3
171297 |
Reduce acoustic noise
in tranny mode when scanning at <600dpi, change motor stepping
for returning scanner head to home position, increase UTA lamp
warm-up time from 20 to 30 seconds, solve problem of left/right
colour balance; EPROM; [source TU971208-020S] |
1.2
191197 |
Modify the algorithm
controlling the UTA lamp exposure position to reduce image noise,
improve colour image quality; EPROM |
